Skip to the beginning of the images gallery

P115W-A2W

Name: P115W-A2W
SKU: P115W-A2W

Be the first to review this product

Harley, Suzuki & scooters with H11 or 9000 series bulb.

Most newer LED bulb replacements have H11 socket.

Availability: In stock

SKU P115W-A2W

$129.95

Details

P115W-A2W

path-product-A2W

P115W-A2W is a plug-in version with Heavy Duty circuitry, which can handle the newer Xenon type bulbs. This unit is EXTERNALLY mounted.

P115W-A2W is designed for Harley, Suzuki, Scooters and many european motorcycle with a 2-pin connector with wider spacing that plugs into the H11 or 9000-series Hi-beam bulb - Halogen or LED. The unit is 1.0" (25.4mm) by 1.35" (34.4mm), and externally mounted. The matching 2-pin connector makes this a plug-n-play operation.

Halogen Headlight Bulbs:

For incandescent Halogen Headlight Bulbs MAX power rating is 115 watts. DO NOT EXCEED!

LED Headlight Bulbs:

For this Option: Special software program controls the modulation with PWM mode for a "softer" transition. Many new LED bulb replacements have this H11 style plug.

CAN-Bus equipped bikes:

For this option: (2) 27 Ohm resistors are used to idle current during off-cycles.

SELECT appropriate OPTION depending on the type of bulb. Options are not interchangeable!

path-inst-A2W

pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using dual p-channel MOSFETs, which are inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the circuits DO NOT utilize the lo-beam whatsoever!

P115W-A2W comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customizable features.

Programmable Daylight Sensor

3-Click Programming: If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity.Current software version v.823A allows 8 linear steps between the high and low end.

The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light.

pathBlazer uses a soft-switching technique. It throttles the current flow through the bulb filament, so that there's no "thermal shock" due to a sudden inrush of current, which can damage the bulb filament or shorten its life considerably. This is far superior than maintaining a small voltage!

Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation.