100HD-M
100HD-M
100HD-M unit is designed to handle up to (4) tail light bulbs - for newer BMWs (EVO equipped), Yamaha (ABS equipped) and newer Harleys.
100HD-M has a built-in ballast to allow continuity during the flash mode. It has a high-side interrupt circuit to allow flashing of the bright brake filaments. This makes it easy with just a single wire splice.
100HD-M unit fits in the tail section or under the seat.
Motorcycle Safety Foundation (MSF) suggests that you pump your brakes at each stop. tailBlazer does it automatically, and by flashing the bulb filament at maximum brightness.
When you apply the brakes the brake light will modulate rapidly at first then slow down to a solid ON over a period of (4) seconds.
WHAT DO THEY SEE?
As soon as you tap your brakes, drivers behind you will see a rapid flash of the brake lights. This sudden flashing invokes immediate attention.
WHAT WILL THEY THINK?
tailBlazer uses a flash pattern which decays exponentially - a well-
recognized deceleration warning. The attention to the initial flashing now changes to a clear recognition that you're beginning to slow down!
Simply flashing brake lights or flashing them on & off will get the attention of drivers behind you, but it doesn't invoke anything else. Every split second of delay in their reaction reduces your safety margin.
The internal circuitry is controlled by a microprocessor, which allows precise flash patterns, overload detection and reverse polarity protection.
Installation does not require any special tools. Everything needed to complete the job is in the product package. Follow the steps described here and refer to the Installation Manual enclosed in the product package.
UPC | 013964190335 |
---|